Going Green Means Saving Water With A Low Flow Shower Head

If you’re looking to go green, one of the best places to start is by taking a look at one of our daily rituals: taking a shower. Have you ever stopped to think where that water comes from and how much of it is being used?

The EPA estimates that showering accounts for 17 percent of indoor residential water use in the United States. That amounts to an astounding 3.3 billion gallons of water per day, and 1.2 trillion gallons per year. This virtual ocean of water is being removed from delicate ecosystems, causing great harm to the environment. While some of this water eventually returns to the environment, much of it does not or does so only with pollution. It may be no surprise, then, that increasing water efficiency should be a high priority for governments and individuals seeking to make a difference for the environment.

One of the best ways to save water is to install a water-saving, low flow shower head. These showerheads are made with technology that manipulates a lower water flow so that you sacrifice none of the luxury you’re used to in your showering routine. Technology can vary from creatively designed orifices that focus the water stream and control water droplet size, to showerheads that inject air into the water to increase the blast.

Low flow shower heads typically use 1.5 to 2.5 gallons per minute (gpm). By contrast, older or non-efficient fixtures use more than 2.5 gpm, with those older than 15 years sometimes using more than 7 gallons per minute!

Not sure if you need one of these water saving shower heads? Try this test: put a bucket marked in gallons under the shower head, then turn on the shower at its normal rate. Use a watch to record how many seconds it takes to fill the bucket to the one-gallon point. If it takes less than 20 seconds then you definitely need a low flow shower head because you’re using way more water than necessary.

In addition to helping the environment, you also save money. Whereas a low flow fixture could run you as little as $15 (a bit more for higher quality ones), the 20% or more in water savings you’d realize would translate to $50-$75 a year on water bills and another $20-$50 a year on energy bills for heating the water. In other words, the showerhead almost immediately pays for itself.

Installing a new shower head is easy. You usually just unscrew the old one, screw in the new one, and you’re done!

If going green matters to you, there is every reason to change to a water saving shower head. There’s not much else you can do that is so easy and makes such a big difference for both the environment and your wallet without sacrificing one bit of luxury.

Technorati Tags:: low flow shower heads